Posts
gretsch tom bearing edge geometry
Thanks Empiredrum. I think what I'm going to do on the tom is re-router with 1/2" radius roundoverbit. The bearing of the bit needs to ride on the o...
17 years agogretsch tom bearing edge geometry
ok -- zero replies. Does anyone know the snare bed depth on 1950 round badge? If not, does anyone know where or who I can go to for this information...
17 years agogretsch tom bearing edge geometry
Looking for the bearing edge cut/geometry for a 1950 Gretsch 12" tom. Low side of cut is towards the outside of the shell. Almost appears to be roun...
17 years agoNovus dealer ??
Any motorcycle dealer should carry Novus as that's what they use to remove scratches from helmet screens and windshields.
17 years agoShell Inner Ply Delaminating
I just performed similar fix on a 1950 Gretsch snare and tom with significant inner ply separation -- after LOTS of internet research and thought --...
17 years agoFixing an out of round shell - web site question
just a thought.... I thought about steam heating the shell and wrapping the outside of the shell with some nylon tie-down ratcheting straps. just a...
17 years agoGretsch delaminate
I just performed similar fix on a 1950 Gretsch snare and tom with significant inner ply separation -- after LOTS of internet research and thought --...
17 years ago