Posts
Behringer Ultracoustic AT108 - 15-watt 8" Acoustic Instrument Amp
SOLD ****** CURRENTLY SELLING FOR $99.99 ONLINE ***** Light, Portable, and Great-sounding Product Dimensions 12.7 x 6.4 x 14.1 inches $25, you pay sh...
7 years agoTRICK DRUMS Tom to Kick Riser for 16" Floor Tom
TRICK DRUMS Tom to Kick Riser for 16" Floor Tom -- $40 This convenient and easy-to-install riser turns an 16" Floor Tom into a Bass Drum. Drum Require...
7 years agoSpeed King-Should I "pre-lube/clean" before the lithium grease?
I agree. White lithium grease gets hard.
7 years agoMic set up for singing?
For me, not using the gooseneck falls into my rules for taking stuff: "One less piece. One less pound."
7 years agoMic set up for singing?
I have a drummer friend that has tried to play and sing to no avail. For him, it is because he counts (in his head) when he plays. When I play and si...
7 years agoNeed part of a cymbal stand, please.
I found one, but thanks so much anyway!
7 years agoMic set up for singing?
Singing drummer here. I use a standard boom mic on my right side coming in at mouth height. No gooseneck. Inexpensive and works good for me.
7 years agoNeed part of a cymbal stand, please.
Looking to buy, beg,or steal a center section form a Ludwig 1400 series cymbal stand, or something similar that will accept the top section of a 1400...
7 years agoVistalite bass drum seam question
I can say that my '73 Vistas came with a hex head bolt to tighten onto the tom holder post. It used the same t-wrench as the nuts on the tom brackets...
7 years agoNeed info on these Zildjians, please.
Thanks, Mike. I have gigged with them off and on for over 40 years. I clean them regularly (gasp!) and store them in terry cloth bags when not set u...
7 years agoNeed info on these Zildjians, please.
Thank you. 18” Zildjian crash cymbal (1550 gr) and 20” Zildjian ride cymbal (2130 gr)
7 years agoNeed info on these Zildjians, please.
I have a couple of cymbals I have had since the late '60s. Just wondering if there are particular names or model designations for them There is an 1...
7 years agoReplacing old straps on vintage fiber cases
Craft stores sell two part rivets that come with a setting tool. The post comes up from the bottom and the cap is pressed on with pressure. They com...
7 years agoLudwig Flat Base Stand Part, Part Two
I cannot say for sure, but I would bet that you need a roll pin. They are used in many types of drum assemblies. The pin is slightly larger than the...
7 years agoLudwig Flat Base Stand Part, Part Two
Thanks, Mike. I thought that was the case, but I wasn't sure.
7 years ago