Posts
What is the best way to mask off the Lug holes on a Snare drum?
Phil: I have a similar project on the back burner and have purchased the correct size dowels to fill the lug, strainer, etc. holes during the finishi...
18 years agoBest glue and method to fix lifting seams
Chris: I spoke to a shop owner and builder in Ohio a couple of weeks ago and he suggested Duco Cement. You could also clamp a narrow board to the ov...
18 years agoROGERS - It is hard to believe, but it is true!
Mike: What a fantastic and rare kit! You are indeed fortunate and very much deserving of that kit! Ken
18 years agoBuddy Rich's Drum Set???
Lighten up, Tommy. Since Rogers' philosophy, particularly in the 60s, was to adapt to drummer's needs, anything was possible. I have had kits that c...
18 years agoBuddy Rich's Drum Set???
Good morning, all: Take a close look at the snare head shot of the Dyna-sonic. The one tone control that is in place is mounted on the snare head si...
18 years agoDyna-sonic parts needed
Hello, all: I am in need of several early B&B era Dyna-sonic parts for a couple of restoration projects and I hope that you might be able to help. I...
19 years ago1964-65 Rogers
Hi, Ziv: Steve Maxwell here in Chicago just listed a silver 60s kit, but with a 14" floor tom, that is probably as close as you will find to what you...
19 years agoRogers XP8
Regarding removal of the contact paper, you might have good luck heating it a bit with a hair dryer to loosen the adhesive. Too much heat may melt th...
19 years agoWood Dynasonic Restoration
Tommy: Of number one importance was the finish coat that was used and now I have that answer.....thank you, Tommy! I haven't gotten into this projec...
19 years agoWood Dynasonic Restoration
Hello, all: I have been fortunate enough to find a late Dayton/early Fullerton wood dynasonic at a reasonable price. So that tells you right there t...
19 years agoany way to repair old cymbols?
Bob: Not sure if there's a fix for the keyholing, but if the cracks radiate out from the hole you may have success in drilling a tiny hole at the very...
19 years agoCleaning old cymbals
I am by no means an expert, but I've used Groove Juice by ProMark successfully on Zildjian cymbals. It is simply applied via spray bottle, left to so...
19 years ago